Your cart is empty
Cleaning a semi-automatic handgun is a relatively straightforward process. Here are the basic steps:
1. Unload the firearm: Before starting any cleaning process, make sure the firearm is unloaded. Check the chamber, magazine well, and magazine to ensure that there are no rounds present.
2. Disassemble the handgun: Follow the manufacturer's instructions to disassemble the firearm. This usually involves removing the slide, barrel, recoil spring, and guide rod. Make sure to do this on a level surface and if possible in a shallow container to contain loose parts.
3. Clean the barrel: Use a bore brush and cleaning solvent to clean the barrel. Run the brush through the barrel several times, then use a patch to remove any residue. Repeat this process until the patch comes out clean. You can also use a barrel snake for quick cleaning.
4. Clean the slide and frame: Use a cleaning solvent and a brush to clean the slide and frame. Pay special attention to the areas where the slide and frame meet, as these are often prone to buildup. Double sided cotton swabs can also help the hard to reach places.
5. Lubricate the firearm: Apply a small amount of lubricant to the barrel, slide, and frame. Be sure to use a lubricant that is recommended by the manufacturer.
6. Reassemble the handgun: Reassemble the firearm according to the manufacturer's instructions. Be sure to check that all parts are properly seated and secured.
7. Function test: Finally, perform a function test to make sure that the firearm is operating properly. This involves checking that the slide cycles smoothly and that the trigger, safety, and other controls function correctly.
Remember to always follow the manufacturer's instructions for cleaning and maintenance, and to use appropriate safety precautions when handling firearms.